When using an automatic packaging machine, the cutter will inevitably fail, so how to deal with the failure of the cutter of the automatic vertical granule packaging machine?

　　During the packaging process, the processing method for the cutter failure of the automatic vertical granule packaging machine is as follows:

　　1. During the operation of the packaging machine, the packaging bag is cut continuously. Check whether the cutting knife is not sharp enough, or there is a gap between the horizontal seal and the horizontal seal, resulting in no contact between the two;

　　2. When the packaging bag is cut out, it is found that there are some sawtooth parts and some are not. Check whether the cutter teeth have fallen off;

　　3. After the packaging bag is cut out, it is found that the left and right sides of the packaging bag are not aligned or check whether the cutting knife of the packaging machine is not installed smoothly or whether there is any installation error.

　　4. When the packaging machine is running, it is found that the cutter does not work: check the screen control panel to see if the control system of the cutter is stopped; check whether the starting time and speed of the cutter on the control panel are consistent with the running speed of the packaging machine; After sealing, check whether the sensor on the cylinder is faulty and whether there are relevant signal instructions; check whether the circuit control system has wrong wiring or circuit problems, whether there is any problem with the solenoid valve, cylinder, etc.