The maintenance of the automatic granule packaging machine is essential for long-term use.

　　Lubrication of parts of automatic granule packaging machine:

　　1. The box part of the machine is equipped with an oil gauge, which should be refueled once before driving, and can be added in the middle according to the temperature rise and operation of each bearing.

　　2. The worm gear box must store engine oil for a long time. The oil level is as high as the worm gear completely penetrates into the oil. If it is used frequently, it must be replaced with new oil every three months. There is an oil plug at the bottom for draining oil.

　　3. When refueling the machine, do not let the oil overflow the cup, let alone flow around the machine and on the ground. Because oil is easy to contaminate materials and affect product quality.

　　Maintenance instructions for automatic granule packaging machine:

　　1. Regularly check the machine parts once a month to check whether the worm gear, worm, lubricating block bolts, bearings and other moving parts are flexible and wearable. If any defects are found, they should be repaired in time and should not be used reluctantly.

　　2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.

　　3. After the machine is used or stopped, the rotating drum should be taken out for cleaning and the remaining powder in the bucket should be cleaned, and then installed properly to prepare for the next use.

　　4. If it is not used for a long time, the whole body of the machine must be wiped clean, the smooth surface of the machine parts should be coated with anti-rust oil, and covered with a cloth.

　　Precautions for automatic granule packaging machine:

　　1. Before each start-up, check and observe whether there is any abnormality around the machine;

　　2. During the operation of the machine, it is strictly forbidden for the body, hands and head to approach or touch the moving parts!

　　3. When the machine is running, it is strictly forbidden to put hands and tools into the sealing knife seat!

　　4. When the machine is working normally, it is strictly forbidden to switch the operation button frequently, and it is strictly forbidden to change the parameter setting value frequently at will;

　　5. It is strictly forbidden to run at ultra-high speed for a long time;

　　6. It is forbidden for two or more colleagues to operate various switch buttons and mechanisms of the machine; the power should be turned off during maintenance and maintenance; when multiple people are debugging and repairing the machine at the same time, they should pay attention to communicating with each other and signaling to prevent accidents caused by lack of coordination.