The automatic filling machine assembly line refers to a form of production organization that realizes product processing through the automatic filling machine system, which is formed on the basis of the further development of continuous linear. All mechanical equipment runs at a uniform speed, the production process is highly continuous, and the products of the automatic filling machine assembly line should have a sufficiently large output.

　　The product design and process of automatic filling machine assembly line should be advanced, stable, reliable, and remain basically unchanged for a long time. The use of automatic filling machine assembly line in mass production can improve labor productivity, stabilize and improve product quality, improve labor conditions, and reduce production. Covering area, reducing production cost, shortening production cycle, ensuring production balance and having significant economic benefits.

　　Knowledge of automatic filling machine line maintenance:

　　1. Synchronous maintenance method: In production, if a fault is found, please try not to carry out maintenance, and take a maintenance method, so that the production line continues to produce until the holiday, contact the maintenance personnel and operators, and repair all problems at the same time, the equipment is unified across the line Production.

　　2. Branch maintenance method: If there is a big problem in the automatic production line, the maintenance time will be long, and the simultaneous repair method cannot be used. At this time, please use the vacation to concentrate on repairing a certain part by the maintenance workers and operators.

　　3. Before the next holiday, please repair the other part to ensure that the automatic production line will not stop production during working hours, in addition, use the pre-repair method as much as possible in the management, install a timer on the equipment, record the working time of the equipment, Using the wear rule to predict the wear of wearing parts and replace the wearing parts in advance can eliminate faults in advance and ensure that the automatic filling machine assembly line can be stable and fully produced.

　　Daily inspection of automatic filling machine assembly line:

　　1. Check and clean the circuit, gas circuit, oil circuit and mechanical transmission parts (such as guide rails) before and after operation.

　　2. During the work process, conduct spot checks on key parts, find abnormalities, record them, and deal with small problems before and after the shift (the time is not long).

　　3. Unified shutdown and maintenance of the automatic filling machine assembly line, formulate a plan for wearing parts, and replace the wearing parts in advance to prevent accidents.